![]() ![]() I hope that someone want to check these for me, it would really be helpful. ![]() So i hope someone has this controller to and want to look in the parameters for me in the Supervisor menu:ΔΆ/press down button until "supervisor" then enter RGH22 C30F00 (so last digits meaning its not a standard RGH22 Linear encoder but specially built for client and has analog read out in uA) Operating Instructions Operating Instructions ND 1200 QUADRA-CHEK Software Version 2. Metronics Quadra Check QC2000 (TOOL-CHEK) So after many hours searching and calling Heidenhain (who bought Metronics) and Renishaw (the encoders) for parameters i still don't know the right parameters, and they don't know either. ![]() I think all parameters are lost because of the repair and replacing the battery. G-SYNC and Quadro Sync were always mutually incompatible features, and this change makes it easier to use G-SYNC capable monitors on Quadro Sync configurations, as it is now no longer necessary to manually disable G-SYNC. On startup i'm able to set the reference points and then its starts but when i move then the readout Description: Driver for NVidia Quadro 2000M Updated the driver to prevent G-SYNC from being enabled when a Quadro Sync board is installed. Now its repaired the controller works again except now the linear encoder read wrong now, or don't read in fact. The PCB had to be repaired after the backup battery leaked acid on the PCB and damaged it. Use this to connect a digital display or, with an adapter, a VGA display using DVI-to-VGA adapter. ![]() Today i tried get out Quadra Chek 2000 working again after the PCB failed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |